5
PROGRAMMABLE FEATURES
The PS-5565TW pager system was designed with flexibility and OEM integration in mind.
The PS-5565TW gives installers the output flexibility that every great installer is looking for. This unit can
be customized and used in almost every possible application.
With the integration of Timed, Latched, or ON / OFF outputs, this unit can single-handedly control
virtually any electrical system in the car!
The programmable features are as follows:
•
IGNITION CONTROLLED DOOR LOCKS
-
ON by default. This feature will LOCK all the vehicle’s doors the first time the driver presses on
the brake pedal after the vehicle has been started. The unit will UNLOCK all doors when the key
is turned to the OFF position.
•
SECURE LOCK
-
OFF by default. This feature can control certain OEM factory alarm systems without connecting
any other wires to the OEM alarm. Some OEM systems use the factory Lock & Unlock wires to
ARM & DISARM the alarm. Upon receipt of a remote start signal, secure lock will unlock the
doors (disarming the alarm), then re-lock the doors a ½ sec. after it remote starts. Most OEM
systems, with the exception of VW will NOT rearm the alarm with the engine running, but WILL
lock the doors. After a shut down, Secure Lock will RE-LOCK all the vehicle’s doors and ARM
the alarm.
•
PASSIVE OR ACTIVE ARMING
-
Passive (1 min timeout) by default. The alarm system on this unit can be set
Active,
(Will NOT
arm itself) or it can be left
Passive
(ARMS itself) with a 1 min timeout.
•
LOCK PULSE DURATION
-
¾ sec LOCK and ¾ sec UNLOCK pulses by default. This system can be programmed to give
4
sec
LOCK /UNLOCK
outputs, (Used to control vacuum door lock system i.e.: Mercedez) or for a
single ¼ sec LOCK pulse and
TWO-¼
sec UNLOCK pulses (Used for double pulse
DISARM/UNLOCK systems i.e.: Maxima, Pathfinder, and Volks…)
•
REMOTE START RUN TIME
-
The PS-5565TW can be programmed to run the engine for
4 / 15 / 25
minutes. Standard default
run time is 15 minutes in Gas mode, and 20 minutes in Diesel mode.
•
VEHICLE TYPE – GAS OR DIESEL
-
Gas mode by default. The unit can be programmed to operate in Diesel mode. In Diesel mode the
system will wait for the glow plug light to go out, for up to 30 seconds, before cranking the
engine. Note that the run time is automatically extended when Diesel mode is selected.
