Polargos EASY WAY201, Руководство пользователя

Страница: 23 / 40

23
GB
3
Parameter setting
Teaching of the movement path of leaves.
The electronic system automatically programmes the following:
The servomotor power necessary to control the gate in the usual mode.
Saving of this information enables the detection of any anomalies in operation of the drive unit.
Gate path in order to complete the opening and closing of the leaves as well as
position of stops.
To start the programming procedure, close the leaves, stand at the usual distance from the
gate and carry out the following operations:
1. Press longer the remote control push-button.
> After several seconds, the gate starts opening
at low speed.
* If the gate does not open properly,
check the servomotor cables as
shown on page 18.
2 . After the gate is open, press longer
the remote control push-button once again.
> The gate closes, one leaf after the other.
3. Press the same push-button once again.
> The gate opens still at low speed.
4 . Press the push-button for the last time.
> Both leaves close almost simultaneously.
After these 4 operations are completed, the indicator PROG goes out; this means the
end of the gate path programming procedure.
The cycle must be complete (2 complete and uninterrupted openings / closings). In
the case of any interruption, the procedure will be suspended and resumed at the
next opening.