Polargos EASY WAY201, Руководство пользователя

Страница: 10 / 40

10
GB
23 1
Crossbar
Electronic module
Junction box
(not included in the delivery)
(cable 2 x 1 mm
2
between drives;
cable 2 x 0.75 mm
2
between photocells)
2 3
Flexible shield ICT
Power supply connection: (3 x 1.5 mm
2
) Connection of 24 V between two drive units: (2 x 1 mm
2
)
1. 2.
Preparation for assembly
Preliminary wiring system
To install the gate drive, proceed as follows:
● Lay down a power supply of 230 V to one of the posts and as close to the drive unit as possible.
● Connect the post together using a cable 2 x 1 mm2 (not included in the delivery).
Provide a shield Orange ICT Ø 25 mm for cables located underground.
If cables cannot be led underground between the posts, use a cable bush that can withstand the
weight of vehicles.
Mains supply
To ensure operation of the gate opening mechanism,
connect a power supply of 230 V – 50 Hz to it.
The electrical supply cable must be:
●
Designated for the gate opening mechanism only.
Protected: - by means of a fuse or a circuit breaker 10 A,
- by means of a differential-current switch (30 mA).
●
Installed in accordance with the safety standards concerning wiring systems and
effective in the country of use.
Multipole disconnection of the power supply is to be provided:
●
using a supply cable with a plug
● or by means of a switch where a distance between contacts is at least 3 mm for
each pole (according to EN 60335-1).
It is recommended to install a lightning arrester (maximum residual voltage 2 kV).