PUM_STR_091201_EN
23/30
0
SAFETY DISCONNECT HANDLE
Function:
This safety coupling opens in case of missue of the system
or failure of the disconnection and can allways be re-used.
Adjustment:
The Safety Disconnect Coupling is delivered complete
assembled with a preset springload.
The standard setting on delivery gives you a release force at
450N.
Release Force
You can adjust SDCA-Coupling by using different springs.
These springs however are not standard and if you require
such springs please contact your Plymovent representative.
Article name
Article number
SDCH-Pneumatic 100mm/ 4”
90550-1011
SDCH-Pneumatic 125mm/ 5”
90555-1011
SDCH-Magnetic 100mm/ 4”
90560-1011
SDCH-Magnetic 125mm/ 5”
90565-1011
9.
MOUNTING INSTRUCTION
- TRIMMING PROCEDURE
WARNING!
After the Safety Disconnect has released please
check if all spring blocks in the product are free
of damage and functioning correctly. Any damaged
parts should be replaced and the correct functioning
should be verified. If not functioning correctly the
Safety disconnect can potentially cause damage to
person or property.
TAILPIPE MODIFICATION OPTIONS
Introduction
In some cases it might me necessary to divert the exhaust flow
from the tailpipe to the side of the vehicle. The Magnetic
Grabber
®
connector can then be installed to this modification.
In order to ensure this is done right please consult the
manufacturer of the vehicle. In order to modify a tailpipe it
might be necessary to combine a number of options.
The example to the right you can see the tailpipe in
combination with a tailpipe reducer pack, a 45˚ bend, and a
tailpipe support bracket. This to support a correct and steady
installation of the Magnetic Grabber
®
connector
Image: possible tailpipe configuration
MAN_MAG_STR_TUV_SUD_180517/2_EN
