PUM_STR_091201_EN
10/30
0
CAUTION
Be sure to order the right Grabber® dimension. If a
incorrect version is used on the tailpipe, the system
could be damaged (too small Grabber®) or will dis-
function (exhaust gasses can enter the premises)
8. INSTALLATION
BACK-IN MEASUREMENT PROCEDURE
Please determine the position of:
1. Exhaust pipe
2. Gate / Exit door.
3. Distance Gate / Exit door vs the exhaust pipe.
1) Determine the location of the exhaust pipe (1) on the
vehicle; which side of the vehicle it is positioned on. i.e.
were does the exhaust exit the vehicle and that diameter
does the exhaust pipe have?
Check if exhaust pipe modification is necessary, see:
”Exhaust pipe modification procedure in this
Product User manual”.
2) Measure the height and width of the gate (2).
Check what type of gate:
- Slidegate
- Overhead gate
- Other type
Check at what height the track can be installed.
The height should be in line with the specifications
indicated in this manual in order to ensure correct
product performance.
3) Measure the distance between the door and the exhaust
pipe (3), this is the required minimal length of the STR-
track. Check before installation that this is the minimum
required length of the STR in Back-in application.
The distance from the end of the track to the door(s)
must be in line with the installation table on page 9.
WARNING
PRODUCT MAY CONTAIN SHARP EDGES
Use care when servicing unit.
Failure to do so could result in minor personal
injury.
3
2
PLAN VIEW
1
MAN_MAG_STR_TUV_SUD_180517/2_EN
