PLEXPACK MPS6100, Продуктовая документация

Страница: 19 / 76

MPS6100 OPERATION MANUAL
ORIGINAL INSTRUCTIONS Page 11
since the most recent startup of the machine. Any history of alarms in previous startups
will be lost once the sealer is powered off.
4.0 OPERATION
4.1 GETTING STARTED
1) If the MPS6100 has been shipped without a power cord it is the responsibility of the owner
to source and purchase a compatible power cord based on the criteria provided below.
a. IEC 60320 compliant.
b. C13 Class 1 Female Cable Connector, see figure 7.
c. 15 A / 250 VAC minimum rating.
d. Entire cable must be a maximum of 4.5 meters in length.
e. Individual wire must be a minimum of 0.75 mm² (1.16x10
-3
in
2
).
2) The black push button located on the front panel is used to power the machine on. The
e-stop will disable all movement and heat output to the sealing bars.
3) Note that as long as the e-stop is engaged the control circuit will be off but the machine
will remain on. The sealer will not be able to run again until the e-stop is disengaged and
the “Start” icon on the left margin is pressed.
4) Once the black push button is pressed, the HMI will turn on and begin its start-up
procedure.
5) The home screen will be displayed on the HMI once the sealer has finished booting up, as
shown in Figure 6.
FIGURE - 7
Female
Male