PLEXPACK MPS6100, Продуктовая документация

Страница: 30 / 76

MPS6100 MAINTENANCE MANUAL
ORIGINAL INSTRUCTIONS Page 2
1.0 MACHINE SETUP AND CONFIGURATION
1.1 LOGGING IN AS TECHNICIAN
All settings regarding sealing parameters and configuration require the user to log in as
“Technician” to avoid any possible deletion or modification of important data. To log in as
“Technician”, click on the “Current user” icon. The login screen will pop-up on the HMI as shown
in Figure 1. Click on the text box to the right of “Password” and type the following password: 1 .
Note, the sealer will automatically log off the technician user after 5 minutes. The user will
have to re-log on to continue manipulating setups and configurations.
1.2 SETUP PARAMETERS
Pressing “Setup Par” on the right margin opens the parameter setup screen shown in Figure
2. The speed and temperature set values are the values the operating set points the user wants the
sealer to run at. The actual values are the current values registered by the sealer. Once the actual
values are the same as the set values (or within a certain range, as specified by the user. See
configurations in section 1.3 for procedure), the sealer is ready to operate.
Also shown in parameters is the current number of products sealed. This value is only
available if the product sensor option is purchased.
An important note is whenever the sealer HMI is inactive for 10 minutes, the setup
parameters screen is shown on the HMI without the left and right margins, for user reference. Once
the HMI is touched the margins will re-appear for user operation.
FIGURE - 1