PLEXPACK MPS6100, Продуктовая документация

Страница: 39 / 76

MPS6100 MAINTENANCE MANUAL
ORIGINAL INSTRUCTIONS Page 11
3.5 RAISING THE IN-FEED RAILS
If the in-feed rails have been lowered to perform maintenance it will be necessary to
raise them once finished. Simply reverse the procedure shown in section 3.4 to raise the rails
back into position. If the drive pulleys or gears have rotated while the in-feed rails have been
lowered it will be necessary to rotate the toothed rail pulley using its drive pins to match the
floating coupling located directly underneath the rubberized drive pulley. If this fails, raise
the rails while the machine is running at a very low speed. This procedure presents exposure
to moving components and can cause injury if not careful.
CAUTION: Rotating and moving components are exposed. Use extreme caution to avoid
entanglement causing personal injury. Do not attempt if loose clothing, jewellery and/or hair
are present, they may become entangled.
1) If the rails fail to snap into place, the alignment of the drive pulleys has shifted out of
position.
2) To realign the pulleys you must reconnect the power to the machine and startup the
sealer.
3) Change the heat zone temperatures close to room temperature.
4) Adjust the speed to a very low value.
5) As the machine runs, very carefully ease the in-feed rails back into position, some
force may be needed to snap the rail into place.
6) At this point, the rails should have snapped into place. Turn off machine and
continue.
7) While holding the rails in place, tighten the four thumb screws shown in Figure 11.