Planex FW-100TX, Руководство пользователя

Страница: 41 / 52

71
FW-100TX
70
Troubleshooting
This section describes problems you might encounter with the FW-100TX
and suggests possible causes and solutions.
● At the device manager of Windows95/98, a "!" symbol is displayed for
the adapter.
There may be a resource conflict. Open the FW-100TX properties with the
device manager and click on the "Resources" tab. If the resource is
conflicting, change the resource of the conflicting device.
● Link LED doesn't light up.
If the Link LED of both the adapter and the hub don't light up even though
the driver has been properly installed AND both the computer and hub are
powered, the network cabling or cable connection maybe bad. Check the
following points:
---
>
Make sure that the network cable is attached firmly on both the adapter
and the hub.
---
>
Ensure that you are not using a crossover cable. You need a straight
type cable to connect to the network.
- - -
>
Try replacing the cable with one which is working properly with
another device. Connect to the network and see if the first cable is bad.
● Cannot communicate even though the driver has been installed properly
and the Link LED is on.
---
>
Check the network protocol setting, work group (domain) setting and
other settings in Control Panel. The protocol and the work group (domain)
name need to be the same throughout the entire network. If you are using
TCP/IP protocol, a unique IP address needs to be assigned to your PC, too.
For the appropriate setting, consult with your network administrator.