Planex FW-100TX, Руководство пользователя

Страница: 24 / 52

37 36
FW-100TX
This chapter describes how to install and configure the driver for the FW-
100TX Ethernet adapter under WindowsNT 4.0.
Under WindowsNT 4.0, there are two driver installation procedures. One of
the procedures is used for systems with no network configuration, while the
other procedure is required for systems whose network settings have been
configured before.
■
Setting up a network for the first time
1. Insert the FW-100TX into a PCI slot of your computer and switch on the
computer to start WindowsNT4.0.
2. Open "My Computer" and then "Control Panel".
3. Double click on the "Network" icon.
Chapter 5
Installation under WindowsNT 4.0
5 1
Installing the Driver
5. Select "Media Type" from the Property and set "Value". You can choose
one of the following settings.
Auto Sense:
The communication rate (100Base-TX/10Base-T) and the communication
mode (full-duplex/half-duplex) are automatically set by the Auto-
Negotiation function.
100BASETX:
The communication rate will be fixed to 100BASE-TX/half-duplex.
100BASETX Full_Duplex:
The communication rate will be fixed to 100BASE-TX/full-duplex.
10BASET (Twisted_Pair):
The communication rate will be fixed to 10BASE-T/half-duplex.
10BASET Full Duplex:
The communication rate will be fixed to 10BASE-T/full-duplex.
6. Click on the "OK" button.
7. Click on the "OK" button again. You will be asked to restart the
computer. Click on the "Yes" or OK button to restart your computer.