Planex CQW-AP108AG, Руководство по установке и настройке

Страница: 129 / 301

5 Configuring Networking Settings
116 Installation and Configuration Guide, (CQW-AP108AG)
Perform the following functions on this tab:
Egress COS
Use the Egress COS tab (Figure 84) to modify the default priorities assigned to 802.11 packets
leaving the AP by creating a COS-to-TCID mapping.
If a TCID to COS mapping is defined, the TCID value is obtained from the mapping table of the
interface based on the COS field of the frame. By default, COS-to-TCID mapping is one-to-one,
i.e. COS 0 maps TCID 0, 1 maps to 1, … and 7 maps to 7. If your network supports fewer than 8
priority levels, you can map multiple COS levels to a single TCID value.
Figure 83: QOS Configuration - Egress COS
Function Steps
Define TCID to COS
mapping 1 Select the radio interface for the mapping.
2
Select a COS value for each TCID value, or select
Default
to accept the
default mapping.
3
Click
Apply
.
Define VLAN-to-COS
mapping
1
Click
Add
.
2
Select the AP interface.
3
Select the VLAN ID. (See “Configuring VLANs” on page 107 for
information on VLAN IDs.)
4
Select a COS value or select
Default
to use the default mapping.
5
Click
Apply
.
Interface-to-COS
1
Click
Add
.
2
Select the AP interface.
3
Select a COS value or select
Default
to use the default mapping.
4 Click Apply .