7
En
PREP
ARA
TION
Before You Start
The Touch Pen & Backlight
The touch pen is located in the back right-hand
corner of the remote control. Take it out by sliding
your finger along the bottom right edge of the
remote control and then grasping the pen with
thumb and forefinger.
The backlight button is located in the top right-hand
corner on the back of the remote control. Use this
button in low-lighting to see the screen more clearly.
Back light switch
Touch pen
Remote Control Cushions
Apply the cushions to the feet of the remote control
as shown in the diagram below.
Operating range of remote
control unit
The area in which you can use the remote control to
operate the VSA-E07 is fairly large. To use, point the
remote control toward the remote sensor on the
front panel of this unit while within the range shown
below.
30
30
7m
Remote control may not function properly if:
• There are obstacles between the remote
control and the remote sensor.
• Direct sunlight or fluorescent light is
shining onto the remote sensor.
• The receiver located near a device
emitting infrared rays.
• Operated simultaneously with another
remote control which uses infrared rays.
Operating other PIONEER
components
Connecting an optional control cord allows you to
operate other PIONEER components simply by
pointing the amplifier’s remote control at the remote
sensor on the front panel of the amplifier. The
amplifier then sends the remote control signals to
the other devices via the CONTROL OUT terminal.
OUT
IN
CONTROL
OUT
IN
CONTROL
PIONEER component
bearing the
Î
mark.
Remote Control
To CONTROL IN
terminal of another
PIONEER component
bearing the
Î
mark.
Amplifier
You can also control PIONEER components
(and those made by other manufactures) by
pointing the amplifier’s remote control
directly at the respective component. This
type of operation does not require control
cords. All you have to do is recall the
appropriate preset code (Refer to"Recalling
setting stored in the remote control" on
page 50)).
