34
En
Initial Set Up
BASS PEAK LEVEL MANAGER
The LFE (Low Frequency Effect) channel in Dolby Digital or DTS program sources can produce heavily
concentrated ultra-low bass tones that may exceed the capabilities of your speaker system. The following steps
show you how to set the peak level for the ultra-low bass (LFE) channel. If continuing from CROSSOVER
NETWORK go to step 1. If starting fresh, complete steps 1-3 in "Setting Up for Surround Sound" (p.26) first.
1
Press the BASS PEAK LEVEL MANAGER
button.
2
Press the TEST TONE button.
The MASTER VOLUME rotates to MIN (----dB).
dB
STEREO
SIGNAL
SELECT
ANALOG SP
A
AUTO
VOLUME
dB
STEREO
SIGNAL
SELECT
ANALOG SP
A
AUTO
VOLUME
3
Use the +/– buttons (or the MASTER
/– on the bottom right of the
remote control) to specify the bass peak
level.
1
Raise the level gradually.
2
Set the bass peak level at the point just before the
tone starts to distort.
A test tone will sound or not depending on which
speakers you have selected. If sub woofer is YES (or
on PLUS) the test tone will only sound from the sub
woofer. If the sub woofer is off and the front and
surround speakers are set to large, front and surround
speakers will sound the test tone.
4
Press the SET button to input the level.
The display on the amplifier will say RESUME and the
MASTER VOLUME will return to its original position.
dB
STEREO
SIGNAL
SELECT
ANALOG SP
A
AUTO
VOLUME
dB
STEREO
SIGNAL
SELECT
ANALOG SP
A
AUTO
VOLUME
5
Press the SETUP OK button.
You may need to experiment with different Dolby
Digital sources before you can get the BASS PEAK
LEVEL set correctly.
If you want to change a setting before proceeding
Use the +/– buttons (or the MASTER /–) to
change the BASS PEAK LEVEL.
System Setup
SPEAKER
SETTING
CROSSOVER
NETWORK
BASS PEAK LEVEL
MANAGER
DYNAMIC RANGE
CONTROL
DIGITAL INPUT
SELECT
CHANNEL DELAY
CHANNEL LEVEL
EXIT
1
Bass Peak Level Manager
SETUP
OK
CANCEL
TEST
TONE
SET
4
2
3
5
CANCEL
+
VOL
+
CD
LINE/
TUNER
TV
CONTROL
MUTING
MASTER VOLUME
SYSTEM
OFF
MULTI
OPERATION
DBY/ON
–
VOL
–
CH
–
FUNCTION
MASTER /–
If you press the CANCEL button no
settings are input to the amplifier but
the screen remains on the remote
control. To escape the screen you
must press the SETUP OK button.
