Getting started
04
23
En
Engli
s
h
Françai
s
Deut
sc
h
Ne
d
erlan
ds
Italiano
E
s
pañol
Chapter 4
Getting started
Using the Auto MCACC setup for
optimal surround sound
The Multichannel Acoustic Calibration
(MCACC) system measures the acoustic
characteristics of your listening area, taking
into account ambient noise, and testing for
channel delay and channel level. After you
have set up the microphone provided, the
system uses the information from a series of
test tones to measure reverb, optimizing the
speaker settings and equalization (Acoustic
Calibration EQ) for your particular room.
1
Important
• The test tones used for Auto MCACC setup
are loud; however, do not turn the volume
down during setup as this may result in a
sub-optimal setup.
• Make sure the microphone and speakers
are not moved during the MCACC setup.
1
Connect the microphone to the MCACC
jack on the front panel.
• Open the front panel door to access the
MCACC jack.
2
Place the microphone at your normal
listening position.
Place it about ear height, and make sure it is
level by using a table or chair.
Make sure there are no obstacles between the
speakers and the microphone.
3
If the system isn’t already on,
switch it on.
4
Press MCACC.
Try to be as quiet as possible after pressing
MCACC
. The volume increases automatically
and the system outputs a series of test tones.
• To cancel Auto MCACC setup before it has
finished, press
MCACC
. The unit will
continue to use the previous settings.
Note
1 You only need to use the Auto MCACC setup once (unless you change the placement of your speakers or your room layout).
iPod DIRECT / USB
OPEN / CLOSE
PHONES
MCACC
ECT/USB
MCACC
Microphone
STANDBY / ON
MCACC
HTZ-LX61DV_En.book 23 ページ ２００８年７月３１日 木曜日 午前９時２６分
