!
No audio is output if the center speaker set-
ting is
SML
or
LRG
and no center speaker is
installed.
!
Audio is heard only over the center speaker if
installed and the center speaker setting is
SML
or
LRG
.
Selecting a cut-off frequency
You can select a frequency, under which
sounds are reproduced through the subwoo-
fer. If the installed speakers include one whose
size has been set to
SML
, you can select a fre-
quency, under which sounds are reproduced
through a
LRG
speaker or subwoofer.
1 Press A and hold until FRONT appears
in the display, then press A to select HPF.
After
FRONT
is displayed, press
A
until
HPF
appears in the display.
2 Press
m
or
n
to select cut-off fre-
quency.
Each press of
m
or
n
selects cut-off fre-
quencies in the following order:
63
80
100
125
160
200
(Hz)
3 Press BAND to return to the playback
display.
Note
Selecting a cut-off frequency is to set a cut-off fre-
quency of the subwoofer
s L.P.F. (low-pass filter)
and that of the
SML
speaker H.P.F. (high-pass fil-
ter). The cut-off frequency setting has no effect if
the subwoofer is set to
OFF
and other speakers
are set to
LRG
or
OFF
.
Adjusting the speaker
output levels
You can readjust the speaker output levels
using a test tone while listening to music.
1 Press A and hold until FRONT appears
in the display, then press A to select FRT-L.
After
FRONT
is displayed, press
A
until
FRT-L
appears in the display.
2 Press
m
or
n
to select the speaker
to be adjusted.
Each press of
m
or
n
selects the speaker
in the following order:
FRT-L
(front speaker left)
CENT
(center
speaker)
FRT-R
(front speaker right)
RER-R
(rear speaker right)
RER-L
(rear speaker left)
SUB.W
(subwoofer)
#
You cannot select speakers whose size is set
OFF
.
3 Press
r
or
q
to adjust the speaker
output level.
Each press of
r
or
q
increases or de-
creases the speaker output level.
+10
10
is
displayed as the level is increased or de-
creased.
4 Press BAND to return to the playback
display.
Note
To adjust the speaker output levels at this mode is
the same as making the speaker output levels at
T TONE
. Both provide the same results.
Adjusting the speaker output
levels using a test tone
A convenient test tone allows you to easily get
the overall balance right among the speakers.
Digital Signal Processor
En
66
Section
12