Adjusting initial settings
1
Initial settings lets you perform initial set up of
different settings for this unit.
1
Function display
Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press F and hold until function name
appears in the display.
3 Press F to select one of the initial set-
tings.
Press
F
repeatedly to switch between the fol-
lowing settings:
Clock
WARN
(warning tone)
AUX
(auxili-
ary setting)
DIMMR
(dimmer)
R-SP
(rear
output and subwoofer controller)
TEL
(tele-
phone muting/attenuation)
A-PLY
(auto
play)
D_ATT
(digital attenuation)
#
To cancel initial settings, press
BAND
.
#
You can also cancel initial settings by holding
down
F
until the unit turns off.
#
When the multi-channel processor (e.g., DEQ-
P7000) is connected to this unit, you can operate
D_ATT
instead of
R-SP
.
Setting the clock
Use these instructions to set the clock.
1 Press F to select clock.
Press
F
repeatedly until clock appears in the
display.
2 Press
m
or
n
to select the segment
of the clock display you wish to set.
Pressing
m
or
n
will select one segment
of the clock display:
Hour
Minute
As you select segments of the clock display
the segment selected will blink.
3 Press
r
or
q
to set the clock.
Pressing
r
will increase the selected hour or
minute. Pressing
q
will decrease the se-
lected hour or minute.
Switching the warning tone
If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
1 Press F to select WARN.
Press
F
repeatedly until
WARN
appears in the
display.
2 Press
r
to turn warning tone on.
WARN :ON
appears in the display.
#
To turn warning tone off, press
q
.
Initial Settings
En
75
English
Section
14
