07
Preparation
17
En
Installing the Plasma Display
Locating
• Avoid direct sunlight. Maintain adequate ventilation.
• The length of the system cable used to connect the
Plasma Display and the Media Receiver is about 3 m
(118 inches).
• Because the Plasma Display is heavy, be sure to have
someone help you when moving it.
• If you place anything on the top of the Media Receiver
it will not receive enough ventilation and will not
operate properly.
• Allow enough space around the upper and back parts
when installing to ensure ventilation around the
backside.
Using the optional PIONEER stand
• For details on installation, refer to the instruction
manual provided with the stand.
• This product may be used only with model PDK-TS04
stand, use with other stands may result in instability
causing possible injury.
Using the optional PIONEER speakers
• For details on installation, refer to the instruction
manual provided with the speaker.
Operating Environment
Operating environment temperature and humidity:
+0°C to +40°C (+32°F to +104°F); less than 85% RH
(cooling vents not blocked)
Avoid installing at the following locations:
• Under direct exposure to sunlight
• Under strong artificial light
• In high humidity
• Poorly ventilated
Over 50 cm (19
11
/
16
inches)
Over 10 cm
(3
15
/
16
inches )
Allowed operation range of the remote
control unit
Operate the remote control unit while pointing it toward
the remote control sensor (
t
) located at the bottom
right of the front panel of the Plasma Display. The
distance from the remote control sensor must be within
7 m (276 inches) and the angle relative to the sensor
must be within 30 degrees in the right, left, upward, or
downward direction.
When the remote control unit does not func-
tion properly
• When any obstacle exists between the remote control
unit and the remote control sensor, the remote
control unit may not function.
• As the batteries become empty, the remote control
unit can function within a shorter distance from the
remote control sensor. Replace the batteries with new
ones early enough.
• The Plasma Display emits very weak infrared rays
from its screen. If you place such equipment oper-
ated through infrared remote control as a VCR
nearby, that equipment may not receive commands
from its remote control unit properly or entirely. If this
is the case, place that equipment at a location far
enough from the Plasma Display.
• Depending on the installation environment, infrared
rays from the Plasma Display may not allow this
system to properly receive commands from the
remote control unit or may shorten allowable dis-
tances between the remote control unit and the
remote control sensor. The strength of infrared rays
emitted from the screen differs, depending on images
displayed on the screen.
30º
30º
Remote
control
sensor
7 m (276 inches)
PDP-ELITE-Eng (17-27)
9/9/03, 11:44
17
