Pioneer Athletics Brite Stripper 3000SP, Инструкция по эксплуатации и каталог запасных частей

Страница: 12 / 48

Operation
12 3A0441A
Clean-up
Perform Pressure Relief Procedure, page 8.
1. Remove Uni-Tip Guard and Uni-Tip.
2. Clean gun filter, Uni-Tip Guard and Uni-Tip in
flushing fluid.
3. Remove siphon tube set from paint and place in
flushing fluid. Use water or pump conditioner for
water-base paint and mineral spirits for oil-base
paint.
4. Turn engine ON and start engine.
5. Close prime valve.
6. Hold gun against paint pail. Disengage gun trigger
safety. Gradually turn pressure control up until
motor begins to drive pump. Trigger gun until flush-
ing fluid appears.
7. Move gun to flushing pail, hold gun against pail, trig-
ger gun to thoroughly flush system. Release trigger
and engage trigger safety.
8. Open prime valve and allow flushing fluid to circu-
late for 1 to 2 minutes to clean drain tube.
9. Raise siphon tube above flushing fluid and run
striper for 15 to 30 seconds to drain fluid.
ti15274a
FLUSH
TI3375A
PAINT
FLUSH
ti3310a
OFF
ON
ti3315a
ti15265a
ti15268a
ti15267a
1 -2 MIN.
ti15266a
PAINT
FLUSH
TI3383A
15-30 SEC.