Pioneer Athletics Brite Stripper 3000SP, Инструкция по эксплуатации и каталог запасных частей

Страница: 18 / 48

Troubleshooting
18 3A0441A
Pump output is low Piston ball is not seating Service piston ball. See pump manual.
Piston packings are worn or damaged Replace packings. See pump manual.
O-ring in pump is worn or damaged Replace o-ring. See pump manual.
Worn, missing, or improperly installed
parts in suction nut Remove suction nut and check that all
parts are present and installed correctly.
Engine speed is too low Increase throttle setting. See Startup,
page 8.
Clutch is worn or damaged Replace clutch, page 28.
Pressure setting is too low Increase pressure. See Startup, page 8.
Uni-Tip filter or tip is clogged or dirty See gun manual.
Large pressure drop in hose with heavy
materials Use larger diameter hose and/or reduce
overall length of hose. Use of more than
100 ft of 1/4 in. hose significantly reduces
performance of striper. Use 1/4 in. hose
for optimum performance (50 ft minimum).
Excessive paint leakage
into throat packing nut Throat packing nut is loose See pump manual.
Throat packings are worn or damaged Replace packings. See pump manual.
Fluid rod is worn or damaged Replace rod. See pump manual.
Fluid is spitting from gun Air in pump or hose Check and tighten all fluid connections.
Reprime pump.
Uni-Tip is partially clogged Clear Uni-Tip. See gun manual.
Fluid supply is low or empty Refill fluid supply. Reprime pump. Check
fluid supply often to prevent running pump
dry.
Pump is difficult to prime Air in pump or hose Check and tighten all fluid connections.
Reduce engine speed and cycle pump as
slowly as possible during priming.
Suction nut is leaking Clean suction nut. Be sure ball seat is not
nicked or worn and that ball seats well.
Reassemble suction nut.
Pump packings are worn Replace pump packings. See pump man-
ual.
Paint is too thick Thin the paint according to supplier rec-
ommendations
Engine speed is too high Decrease throttle setting before priming
pump.
High Engine Speed at no
load Incorrect throttle setting Adjust throttle cable as needed
Worn engine governor Replace or service engine governor
Problem Cause Solution