Operation
Operating Manual PMI 6 primo
1004647-EN-02
49
}
Configure the interfaces
}
Delete the user program
Prerequisite:
}
The PC and PMI 6 primo are connected via the Ethernet interface.
Status of LED:
}
The LED is lit continuously.
8.1.2.6
"RUN" operating status
In "RUN" operating status
}
All system sections are in a RUN condition and are operating without error.
}
A PLC user program is run as part of each cycle.
}
It is possible to communicate with the motion control software in the terminal program
via the command language.
Status of LED:
}
The LED flashes slowly.
8.1.2.7
"STOP" operating status
In "STOP" operating status
}
No user program is run.
}
The system is operating without error.
}
It is possible to communicate with the motion control software in the terminal program
via the command language.
Status of LED:
}
The LED is lit continuously.
8.1.2.8
"Fatal Error" operating status
"Fatal Error" operating status is reached when an error occurs.
}
The function is disrupted long-term. The operating status is adopted temporarily.
}
The motion control software automatically changes back to the operating status "Star-
tup Motion Control Software".
}
The error is entered in the error stack.
Status of LED:
}
The LED is switched off.
8.1.3
Change in operating status
-->
0
Change of all operating states change to "Power Off"
The system changes to "Power Off" operating status when the 24 VDC supply voltage has
been switched off.
0
-->
1
Change from "Power Off" to "Startup Operating System"
