162
The number of discrete frequency points in the sweep will be calculated
according to the specified sweep time.
SWEepe:TIME?
Query the sweep time. The sweep time in seconds will be returned.
SWEep:STATe{OFF
︱
ON}
Disable or enable the sweep mode. The default is Off. To avoid multiple
waveform changes, you can enable it after setting up the modulation
parameters.
Only one type of modulation can be activated at one time. Also when Sweep is
activated, modulation or burst mode will be disabled.
SWEep:STATe?
Query the sweep state. “0” (OFF) or ”1” (ON) will be returned.
SYSTem:ERRor?
Query and clear one error from the waveform generator’s error queue. Up to 20
errors can be stored in the queue. Errors are retrieved in first-in-first-out (FIFO)
order. Each error string may contain up to 255 characters. The waveform
generator beeps every time it detects an error unless the beeper is turned off.
Errors are cleared once you read them.
If more than 20 errors are detected, “too many Errors” show up in the last place
of the error queue. Unless user read the errors in the queue, the additional
errors will not be stored. If there is no error in the error queue when you read it,
“No error” string will be displayed.
SYSTem
:BEEPer
Issue a single beeping tone.
SYSTem:BEEPer:STATe {OFF|ON}
Disable or enable the beeper.
SYSTem:BEEPer:STATe?
Query the beeper state. Return “0” (OFF) or “1” (ON).
