Piazzetta MARCELLA, Инструкция по установке, использованию и техническому обслуживанию

Страница: 22 / 52

- Replace the removed pipe [D] with the side flue gas outlet connection
[E] to be found in the kit, inserting it fully into its seat and taking
care to seal it with a gasket and a silicone-based (not cement-based)
sealant. (Fig. 37)
- Secure the flue gas outlet connection [E] with the previously removed
screw [C].
- Refit the smoke sensor, ensuring that it is fully inserted and securing it
with the screw [B], which must not be overtightened. (Fig. 38)
- Refit the rear panel [A].
- Take the previously removed left side panel and use a screwdriver to
remove the knockout [F] to be found in the lower part, taking care not
to scratch or buckle the panel.
Apply the edge gasket [G] provided in the kit around the edge of the
hole made in the panel. Cut off any excess gasket. (Fig. 39)
a
It is advisable to secure the gasket with a few drops of high
heatresistant silicone.
- Refit the left side panel, proceeding with the steps described for
removal in the reverse order.
- Connect to the flueway in accordance with the instructions given in
the section “
GENERAL RULES
”.
a
When installing with side flue gas outlet, the MINIMUM
distance of the flue gas outlet pipe from the stove is given in
the paragraph “DIMENSIONS”.
This measurement is obtained by inserting a pipe with diameter
2.95” (75 mm) and length 8.62” (219 mm) (measurement H -
Fig. 40) between the side flue gas outlet connection and the
union tee.
- Finish installing the cladding.
E
E
B
C
G
F
H
Fig. 37
Fig. 38
Fig. 39
Fig. 40
H07029330 / DT2001081 – 02 22
English
DT2032326-00
DT2032327-00
DT2032472-01
DT2032440-00