Piazzetta MARCELLA, Инструкция по установке, использованию и техническому обслуживанию

Страница: 20 / 52

The appliance is designed for connection to an external room thermostat
(not included in the package).
To connect the thermostat use a 2x0.5 mm
2
cable secured with a PG7
cable gland to be inserted in the relative hole in the rear panel (Fig. 30).
Only authorised personnel should carry out this operation.
a
Installation can be carried out with any type of room thermostat
but requires a PG7 cable gland similar to that shown in fig. 29.
To connect the room thermostat to the electronic board, refer
to the wiring diagram.
To install, proceed as follows:
- Cut off the electricity to the appliance.
- Remove the right side panel (see the paragraph REMOVING THE
CLADDING ).
- Remove the knockout to be found in the rear panel (position 4 – Fig.
26).
- Clamp the thermostat cable with the PG7 cable gland and insert the
gland into the hole in the rear panel (Fig. 30).
- Connect the thermostat terminal to the two-pin terminal of the
electronic board (Fig. 28).
- Refit the panel, proceeding in the reverse order to removal.
DT2011598-00
5.2 INSTALLING ThE ExTERNAL ThERMOSTAT
1 Thermostat
2 Electronic board 2-pin terminal
3 Cable gland PG 7
4 Thermostat cable terminal
Fig. 28
1
2
3
4
Fig. 29 Fig. 30
If work has to be carried out inside the cladding, the side panels must
be removed as follows:
- Remove the upper grille [A] after unscrewing the 4 fastening screws
[B]. (Fig. 31)
- Remove the 2 screws [C] that secure the lower front panel [D], lift it
slightly and then pull it outwards to remove. (Fig. 32)
DT2011600-00
5.3 REMOvING ThE CLAddING
A
B
D
C
Fig. 31
Fig. 32
H07029330 / DT2001081 – 02 20
English
DT2032462-00
DT2030076-00 DT2032284-00
DT2032464-00
DT2032465-00