Piazzetta MARCELLA, Инструкция по установке, использованию и техническому обслуживанию

Страница: 36 / 52

Description of activity Display
Located on the pellet hopper, its function is to prevent excessive temperature ranges.
If the pellet hopper temperature reaches critical levels, the thermostat cuts off the
power supply to the fuel-loading auger, thereby stopping the supply of pellets to the
grate and starting the stove shutdown process.
- The readout ‘ ALC ’ appears in the STOVE STATUS mode.
- After approx. 60 seconds the alarm sounds (if activated).
TANK TEMP SAFETY
WHAT TO DO:
- Shut down the stove by holding the ON/OFF key down for several seconds.
- The alarm will stop.
- Wait until combustion of any pellets remaining in the grate has finished.
- After having cleaned the grate, restart the stove by pressing the ON/OFF key. (The
readout
TANK TEMP SAFETY
must no longer appear on the display. If this is not the
case repeat the process described above.)
Description of activity Display
Its function is to check correct operation of the flue gas fan so that the stove can be
used in all safety.
If the black-red-white cable connected to the flue gas fan (see the paragraph “
WIRING
DIAGRAM
”) momentarily or accidentally removed from its normal position, or is not
connected properly to the electronic board, or the speed of the smoke fan is greater or
lower than the set value according to settings smoke parameter, the readout “
ALF 3 ”
or “ ALF 4 ” will appear in STOVE STATUS MODE.
- The readout “ SMOKE FAN FAILURE ” appears on the display.
- After approx. 60 seconds the alarm sounds (if activated).
SMOKE FAN FAILURE
WHAT TO DO:
- Shut down the stove by holding the ON/OFF key down for several seconds.
- The alarm stops.
- Call the After-Sales Service Centre.
PELLET HOPPER HOUSING TEMPERATURE
DT2010995-00
FLUE GAS FAN RUNNING
DT2012666-00
Description of activity Display
Its function is to check correct operation of the pressure switch so that the stove can
be used in all safety.
It activates during the “START” stage of the stove (see “STARTING THE STOVE” table).
If an anomaly is detected in the pressure switch, the readout “
ALF 2 ” appears in the
STOVE STATUS mode.
The readout “
SAFETY SMOKE
” appears on the display.
After approx. 60 seconds the alarm sounds (if activated).
SAFETY SMOKE
WHAT TO DO:
- Shut down the stove by holding the ON/OFF key down for several seconds.
- The alarm stops.
- Call the After-Sales Service Centre.
H07029330 / DT2001081 – 02 36
English