PIAGGIO Liberty 50 Catalyzed, Руководство по ремонту

Страница: 51 / 165

rent is 1.5 - 2A with lights off. By increasing the
engine revs number, the recharge voltage and cur-
rent progressively increase, at speeds higher than
4000 revs/min. the recharge current should be
about 4.5A; by turning on the lights, the stoplight
and using the horn, the current values may be
≥
5A
and the voltage value 14 - 14.5V (regulator thresh-
old value).
If different values are obtained, replace the reg-
ulator, otherwise check the wires and connec-
tions.
Electric characteristic
Voltage regulator resistance
~ 8 M
Ω
4) TURN INDICATORS NOT WORKING
If the turn indicators do not work, do the following:
- Disconnect the regulator connection and insert
the multimeter probes between the white cable (3)
and the black one (2).
- Turn the key switch to ON and check that the
battery is getting voltage. If no voltage is detected,
repeat the test now between the white cable and
the earth; if there is no voltage even after this op-
eration, check the wiring and the contacts of the
key switch and the battery. If voltage in the battery
is detected (black cable), check the regulator earth
wiring.
- If the above tests have positive results, jump the
contacts 5 (blue/black) and 3 (white) on the con-
nector, set the key switch to ON and the turn
indicator switch left and right to see when the lights
are steadily on (as they are powered directly from
the battery).
If even after this operation the turn indicators fail
to turn on, check that the wiring is not damaged
and the switch works properly. If these last two
Liberty 50 Catalyzed
Electrical system
ELE SYS - 51