Jumper
PHYTEC Meßtechnik GmbH 1999 L-356e_2
33
4.12.2
Chip-Select Signals S3 (switch 2 and 3)
The C161 Controller provides up to five Chip-Select Signals at Port
P6. The number of Chip-Select Signals active can be defined during
system reset through configuring P0.9 and P0.10. This configuration
can be done with DIP-Switch S3 (switch 2 and 3). These pins are
open in the default configuration meaning that all Chip-Select Signals
are active. Please note that /CS0 and /CS1 are used to control the
Flash devices on U8 and U9 and the RAM on U10 and U11. Hence
3 Chip-Select Signals are available for other purposes.
Chip-Select Signals
S3 switch 2
S3 switch 3
five (/CS0-/CS4)
OFF*
OFF*
three (/CS0-/CS2)
ON
ON
two (CS0-/CS1)
OFF
ON
none
ON
OFF
* = Default
-Setting
4.12.3
Segment Address Lines S3 (switch 4 and 5)
The C161 controller family allows user configuration of the number
of address-lines available for segment addressing at port P4. The
configuration of port P0.11 and P0.12 during system reset specifies
the number of active address lines. This configuration can be done
with DIP-Switch S3 (switch 4 and 5).
Segment Address Lines
S3 switch 4
S3 switch 5
only A16 and A17 are active
OFF*
OFF*
four A16 - A19 are active
ON
ON
all A16 - A23 are active
ON
OFF
none are active
OFF
ON
* = Default
-Setting
Содержание kitCON-161CS
