Phoenix Geophysics MTU-TXC, Руководство пользователя

Страница: 31 / 34

25 Chapter 1
Shutting down the MTU-TXC
25
Fig. 1-16: WpTab window.
The MTU-TXC begins controlling the current source or receiver
according to the schedule.
5. Close the Raw Parameter Table Interface program.
Note If you turn on the MTU-TXC or change the active table
just after the UTC-synchronized start-time of a low
frequency, there will be a noticeable delay before the
next start-time, when transmission will begin. At very
low frequencies, this delay could be 20 min or more.
Saving settings
If you want the MTU-TXC to use the same schedule
next time it is powered on, you will need to save the
settings. Otherwise, when the power is cycled, the unit
will return to default values and will not send a
controlling frequency.
To save schedule settings:
1. Launch the WinHost program.
2. On the right side of the main window, click the Save
Settings button.
Shutting down the MTU-TXC
To avoid damage to the MTU-TXC, care must be taken
to shut it down properly.
To shut down the MTU-TXC:
1. Toggle the red power switch to the off position and
release it.