Phoenix Contact 1153079, Руководство по установке и запуску

Страница: 25 / 54

Mounting and installation
108413_en_06 PHOENIX CONTACT
25 / 52
3.3 Connecting to the network
The network can be connected (depending on the device) via RJ45 ports using twisted pair
cables (IEEE 802.3i/u/ab).
3.3.1 Using RJ45 Ethernet connectors
Connecting RJ45 Ethernet connectors
• Observe the correct connector coding (see also Table 3 - 2 ).
• Only use twisted pair cables with an impedance of 100

and a length of maximum
100 m (per segment).
• Only use shielded twisted pair cables and corresponding shielded RJ45 connectors. In -
sert the Ethernet cable with the RJ45 connector into a port of the twisted pair interface
(network interface 1 or 2), until the connector engages with a click.
NOTE: Connect the network connections (Ethernet) of the device to LAN installations on -
ly. Some telecommunications connections also use RJ45 connections; these must not be
connected to the RJ45 connections of the device.
For operation with 1000 Mbps (Gigabit), the following applies: Cables with four twisted
pairs (eight wires) that meet the requirements of CAT5e as a minimum must be used.
Table 3 - 2 Pin assignment of the RJ45 connectors
Pin number 10Base-T (10 Mbps/s) 100Base-TX (100 Mbps/s) 1000Base-T (1000 Mbps/s)
1 TD+ (transmit) TD+ (transmit) BI_DA+ (bidirectional)
2 TD- (transmit) TD- (transmit) BI_DA- (bidirectional)
3 RD+ (receive) RD+ (receive) BI_DB+ (bidirectional)
4 – – BI_DB- (bidirectional)
5 – – BI_DC+ (bidirectional)
6 RD- (receive) RD- (receive) BI_DC- (bidirectional)
7 – – BI_DD+ (bidirectional)
8 – – BI_DD- (bidirectional)