Phoenix Contact 1153079, Руководство по установке и запуску, Страница: 6 / 54

FL MGUARD 1000 product family
6 / 52
PHOENIX CONTACT 108413_en_06
1.5 Modifications to the product
Modifications to hardware and firmware of the device are not permitted.
– Incorrect operation or modifications to the device can endanger your safety or damage
the device. Do not repair the device yourself. If the device is defective, please contact
Phoenix Contact.
1.6 Safety notes
To ensure correct operation and the safety of the environment and of personnel, the device
must be installed, operated, and maintained correctly.
NOTE: Installation only by qualified personnel
Installation, startup and maintenance of the product may only be performed by qualified
specialist staff who have been authorized for this by the system operator. An electrically
skilled person is someone who, because of their professional training, skills, experience,
and their knowledge of relevant standards, can assess any required operations and rec -
ognize any possible dangers. Specialist staff must read and understand this documenta -
tion and comply with instructions. Observe the national regulations in force for the
operation, functional testing, repairs and maintenance of electronic devices.
NOTE: Risk of material damage due to incorrect wiring
Connect the network connections of the device to Ethernet installations only. Some tele -
communications connections also use RJ45 jacks; these must not be connected to the
RJ45 jacks of the device.
NOTE: Electrostatic discharge
The devices contain components that can be damaged or destroyed by electrostatic dis -
charge. When handling the devices, observe the necessary safety precautions against
electrostatic discharge (ESD) in accordance with EN 61340-5-1 and EN 61340-5-2.
NOTE: Requirements for the power supply
The module is designed exclusively for operation with safety extra-low voltage
(SELV/PELV). In redundant operation, both power supplies must satisfy the requirements
of the safety extra-low voltage.
NOTE: Requirement for control cabinet/control box
This module snaps onto a DIN rail inside a control cabinet or control box. This control cab -
inet/box must meet the requirements of EN 60950-1: 2006 with respect to fire protection
enclosure.
NOTE: Requirement for functional grounding
Mount the module on a grounded DIN rail. The module is grounded when it is snapped
onto the DIN rail.
NOTE: Requirement for mounting location
The prescribed mounting position is vertical on a horizontally mounted DIN rail. To allow
air to circulate freely, the vents must not be covered. A gap of 3 cm between the vents of
the housing is recommended.