Philips FW-D5/21, Руководство по обслуживанию

Страница: 70 / 100

9-8
PCS 103 852
SERVICING THE DVD MODULE AND MONO BOARD
For repair on the DVD module (Basic Engine and the mono board), refer to Service Document:
2nd line Service Manual DVD-Monoboard ....................................................... 3122 785 10045
Caution
This information is confidential and may not be distributed. Only a qualified service person
should reprogram the mono board.
After replacement/repair of the mono board, the customer settings and also the region code may be lost.
Reprogramming of the mono board will put the player back in the state in which it has left the factory,
i.e. with the default settings and the allowed region code.
Reprogramming is limited to 25 times.
When the counter reaches 25, reprogramming is not possible anymore.
Reprogramming will be done by way of the remote control.
Put the player in stop mode, no disc loaded.
Press the following keys on the remote control:
<PLAY> followed by numerical keys <1> <5> <9>
The display shows:
“ - - - - - - - - - - - ”
Press now successively the following keys :
for FW-D1/21 :
<0><4><4> <0><0><0> <0><0><0> <0><0><0> Latam
for FW-D1/21M :
<0><4><2> <0><0><0> <0><0><0> <0><0><0> AP
for FW-D1/33 : <0><4><2> <0><0><0> <0><0><0> <0><0><0> AP
for FW-D5/21 : <0><1><4> <0><0><0> <0><0><0> <0><0><0> Latam
for FW-D5/21M : <0><0><5> <0><0><0> <0><0><0> <0><0><0> AP
for FW-D5/22 : <0><0><1> <0><0><0> <0><0><0> <0><0><0> Europe
for FW-D5/30 : <0><1><2> <0><0><0> <0><0><0> <0><0><0> AP
for FW-D5/33 : <0><0><5> <0><0><0> <0><0><0> <0><0><0> AP
for FW-D5/37 : <0><0><4> <0><0><0> <0><0><0> <0><0><0> US
Press
<PLAY> again.
The TV screen will become BLUE during a short time to confirm that the digital board has been
reprogrammed, then the set goes to standby mode.
Reprogramming of Mono Board
RESET OF VIRGIN MODE
After the player has been powered up for test by the dealer,
it would have gone through the Virgin Mode. It is possible to
reset the settings made during that mode before the delivery
of player to the customer.
This is done by executing the Eeprom Format while in the
Service Test Program (see page 3-6)