37
OPTIONAL COMPONENT
4.
Remove the caps (both outside and inside) covering the
access port for refrigerator and take out the thermal
insulation in the access port. Pass the recorder sensor to
the refrigerator through the access port [Fig. 4]. Then
replace the thermal insulation and caps (both outside and
inside). Also, replace the cap on the port for taking out
the recorder sensor.
Make a cut on the caps to pass the capillary tube as
shown in the Fig. 5.
5.
Fix the recorder sensor to the attachment hole on the
back side of the refrigerator by using the large clips
enclosed with the recorder fixture (MPR-S30). [Fig. 6]
6.
Arrange the capillary tube so that it cannot contact the
shelf.
Care should be taken for the following points to avoid
the crush of the tube when bending the capillary tube.
・
Do not bend the capillary tube for 30 mm from the edge of
the sensor.
・
Do not bend and extend the capillary tube repeatedly at
the same point.
・
The bending should be R10
～
R15.
7.
Operate the unit until the refrigerator temperature gets to the set temperature. Check the recorded
temperature and refrigerator temperature displayed on the control panel. Adjust the zero adjustment
volume on the temperature recorder so that the recorded temperature can corresponds with the displayed
temperature if they are not compliance each other.
Fig. 4
Access
port
Capillary
tube
Clip
Recorder sensor
Fig. 5
Fig. 6
