English
Hydraulic Jacks MH 50; MH 100; MH 250
F 06.01.053/001
technische Änderungen vorbehalten
all rights reserved for any design changes
changements techniques sous réserve
Seite / page 10
Revolving claw
The claw must always be positioned above the base so that it can
rotate 360 degrees, allowing use in more tightly restricted areas.
(only 5t and 10t design)
Revolving pumping unit
Toe jack MH 5T and 10t:
the lever of the pump can be turned 360°
Toe Jack MH 25 t with adjustable undercarriage:
Toe jack MH 25 t: The height of the under carriage can be adjusted with an adjusting
screw
c
.
The load must be applied to the bottom plate – not on the wheels of the undercarriage.
Turn the pump lever in clockwise direction.
Toe jack MH 25 t: use the 2-part lever of the pump.
This lever can be positioned in two positions.
The locking device is effective with the split pin.
Lifting:
Close the release valve by turning in a clockwise direction.
Lift the load with up und down movement of the lever.
Lowering:
While lowering, ensure no obstructions are blocking its travel.
If necessary, lift slightly to remove any supports used to support the load.
Slowly loosen the release valve by turning it in a counter clockwise direction.
Note:
The further the release valve is loosened, the faster the load will be lowered.
The operator is responsible for ensuring a precise, gentle lowering of the
load.
After use, completely insert the pump rod.
When the jack is not loaded, it is necessary to press on its head to lower it.
Sicherheitsbolzen
safety pin
broche de sécurité
1