Permaquip Kubota RTV X900 RRV, Руководство по эксплуатации и техническому обслуживанию

Страница: 30 / 72

MAN-M-O-220_01 24/01/2019 Page 30 of 72
6.7. Start-up
Observe the operating parameters defined in the Technical Specification.
Observe the operating restrictions and safe working practices as defined
by national and local regulations.
In the event the vehicle needs to be restarted following an emergency or
accidental stop utilising one of the emergency stop buttons, repeat the
start-up procedures.
•
Ensure that all E-stops have been reset.
•
Ensure the Road / Rail mode switch is switched to Rail mode.
•
Ensure that the road wheels are in line with the track and the steering has
been locked with the green LED illuminated.
•
Ensure the rail gear is correctly deployed with the green LED lights illuminated
showing the rail gear is locked down.
•
Ensure that the transmission is in 4WD and the differential lock is not engaged.
•
If there is poor light conditions or reduced visibility switch the rail light switch to
“ON”
•
Check the rear-view CCTV system is working and correctly orientated. See
“CCTV” section of this manual.
•
Connect any towed or propelled trailers see “Towing & Propelling” section of
this manual.
The vehicle is now ready to be driven on the track.
Before the vehicle is manoeuvred on the track, the following procedure should be
performed:
•
Removing the dummy plug from the marker light sockets front and back on
the vehicle, check that the break-away warning buzzer sounds at the driving
position and that it ceases when the marker light board is plugged in.
•
Start the vehicle engine and check that the E-stops will stop the engine, front
cab and passenger tub. Reset E-stops after tests.
•
Restart the engine, removing the orange dummy plug from the front personnel
carrier E-stop connection, check that the engine stops. Re-insert after test.
•
Restart the engine. Make sure that all personnel are clear. Turn on the trailer
brakes, release the vehicle hand brake and check that all the connecting
trailer brakes release. Re-apply the hand brake and check that the trailer
brakes are applied.