Permaquip Kubota RTV X900 RRV, Руководство по эксплуатации и техническому обслуживанию

Страница: 32 / 72

MAN-M-O-220_01 24/01/2019 Page 32 of 72
6.10. Lifting Directly Off the Track
•
Drive the vehicle under the crane lifting position and apply the handbrake.
•
Turn trailer brake switch to “OFF”.
•
Raise the
front and rear rail gear, refer to the section ‘Raising the Rail Gear’.
•
Switch the steering lock to “OFF”, the green LED light should extinguish and
the red LED should illuminate.
•
Check the rail lights switch is switched to “OFF”.
•
Switch the travel mode switch to Road mode.
•
Switch the vehicle ignition off. Exit the vehicle during lifting.
•
Press and remove the index pins from both sides of the tub. Lift the tub to gain
access to the rear lifting points.
•
Attach the central lifting point of the wire rope sling to the crane or Hiab lifting
hook. Attach the four sling hooks to each of the lifting points ensuring the sling
is not twisted or caught around any parts of the Kubota. Take up the slack.
•
Lift the Permaquip Kubota off track and slowly lower to the designated area.
•
Remove the wire rope sling.
•
Lower the tub down onto the rests and re-insert the index pins on both sides.
•
Switch the vehicle into road mode.
6.11. Raising the Rail Gear
•
Ensure the vehicle engine is running, it is in rail mode, the handbrake is
applied and the vehicle is in the required position to off track.
•
Press and hold the rail gear switch to "FRONT". Then the hydraulic lever to the
side of the driver’s seat can be moved to the up position to raise the front rail
gear. The green LED should extinguish. When the wheels are fully raised, the
red LED should illuminate. The hydraulic lever can then be released and the
rail gear switch can be released.
•
The front rail gear is now correctly raised.
•
Press and hold the rail gear switch to "REAR". Then the hydraulic lever to the
side of the driver’s seat can be moved to the up position to raise the rear rail
gear. The green LED should extinguish. When the wheels are fully raised, the
red LED should illuminate. The hydraulic lever can then be released and the
rail gear switch can be released.
•
The rear rail gear is now correctly raised.
•
Switch the vehicle into road mode and drive the vehicle of track.