Permaquip Kubota RTV X900 RRV, Руководство по эксплуатации и техническому обслуживанию, Страница: 42 / 72

MAN-M-O-220_01 24/01/2019 Page 42 of 72
14. DEFINED WORDS
The following outlines the defined words used within this Maintenance Programme.
Term Action required
Adjust Correct to defined limits
Change Remove the original and fit a new or overhauled part or assembly in its place.
Check Determine a particular nominated condition before, during or after repair, for
example completeness, security, position
Clean Remove all dirt and deposits
Defective Any fault or faults in a component or assembly, for example structural fractures
or weld fractures, which may prevent the component or assembly from fulfilling
its designed purpose
Dismantle Take to pieces
Examine Determine general condition before repair, for example wear, cracks, splits,
leaks, scoring, erosion, breaks, distortion, looseness
Gauge Determine a nominated dimension by using suitable measuring equipment, for
example ruler, micrometer, callipers, feeler gauges or Go/No-Go gauge
Inspect Determine general condition after repair and attention, that is, conformity to
required standards
Lubricate Apply lubricant
Overhaul Do what is necessary to make an assembly or sub-assembly re-usable, that is
dismantle, strip, clean, examine, fit new parts, repair, re-assemble, test and
inspect as required
Paint To impart colour to a surface
Re-assemble Put together
Record Put down in writing a finding from examination, test, inspection or special
checks.
Rectify To set right
Refit Put back and re-connect
Remove Disconnect and take off
Renew Remove, scrap the original part and put a new part in its place
Repair Restore an original part to the required condition by hand tooling, machining,
build-up, welding, patching, bending, setting, heat-treating, re-securing etc.
Strip Remove covering, that is, paint, polish, fabric
Test Prove correct operation by trial