Permaquip Kubota RTV X900 RRV, Руководство по эксплуатации и техническому обслуживанию

Страница: 50 / 72

MAN-M-O-220_01 24/01/2019 Page 50 of 72
to infrastructure controller
Record Diameter greater than 246mm On Site
⓿ ⓪
67
Rail wheels back
to back
Record
1360mm - 2mm, +3mm at top and
bottom of wheel when loaded and
unloaded
Workshop
⓿ ⓪
68 Fire extinguisher
Check Present in correct location On Site
⓪ ⓿
Check In date and indicator in "OK/green" zone On Site
⓪
69
Towing pins and
tow bar
Check
Present and secure. No damage, chain
and lynch pins attached and good
condition
On Site
⓪ ⓿
70
Leaks under
vehicle
Check
No leaks should be present under the
vehicle
On Site
⓪ ⓿
71 Cab and tub Check
Clean and tidy. Check tub safety chain is
present and in good condition
On Site
⓪ ⓿
72 Bodywork Check
No damage and yellow areas clean, not
faded or discoloured
On Site
⓪ ⓿
73
Brake test -
static
Check
Vehicle does not move when hand or
footbrake applied
On Site
⓪ ⓿
74 Brake test
Check
10mph, driver only, unladen. Maximum
stopping distance 16m
On Site
⓪ ⓿
Record
5mph, driver only, laden. Maximum
stopping distance, 6m
On Site
⓪
Record
20mph, driver only, laden. Maximum
stopping distance 60m
On Site
⓪
75 Track operation Check No vibration, noise or steering problems On Site
⓪ ⓿
76 Labels Check
Clean and Present. See Permaquip
Manual.
On Site
⓪ ⓿
77 Wire rope sling Check
Present and damage free, if signs of any
damage check to LOLER requirements
On Site
⓪ ⓿
78
Break away
warning
Check
Buzzer sounds when marker lights
disconnected (both ends)
On Site
⓪ ⓿
79 Engine stops Check
Check engine stop and rear bay engine
stop cuts out engine
On Site
⓪ ⓿
80
Operation of
trailer failsafe
brakes
Check
Trailer brakes apply when the handbrake
on the attached Kubota is applied.
On Site
⓪ ⓿
Check
Trailer brakes apply when the footbrake
on the attached Kubota is depressed.
On Site
⓪ ⓿
Check
Trailer brakes apply when the brake
system is switched off.
On Site
⓪ ⓿
Check
Trailer brakes apply when the marker
lights are disconnected.
On Site
⓪ ⓿
81
Trailer failsafe
brakes - pump/oil
tank
Check Oil level with top of tank body. On Site
⓪ ⓿
Check
Pressure 110 ± 30 bar at front and rear
connections.
Workshop
⓪
82
Trailer failsafe
brakes - working
pressure / air
tank
Check
Air brake reservoir pressure reaches 8
bar minimum.
On Site
⓪ ⓿
Check
Drain any residual moisture from air
reservoir via test point on the bottom of
the tank.
On Site
⓪