Pentair Fleck 3200NT, Руководство по обслуживанию

Страница: 22 / 52

Page 22
Diagnostic Programming Guide
When the Diagnostics Mode is entered, all available displays are viewed as needed. Depending on current option
settings, some displays cannot be viewed.
Overview Diagnostic Mode
The current diagnostic will be displayed until Extra Cycle key is pressed. There is no time limit on each display.
The timer will display local information, not system information. In the event of regeneration occurring while
displaying diagnostics, the regeneration step and time remaining will be displayed. When regeneration has been
completed, the display will return to diagnostic display.
Entering and Exiting Diagnostic Mode
Push and Release the “D” button to enter. Pressing the Extra Cycle button will move to the next diagnostic to be
displayed. Push the Extra Cycle button once per display until all are viewed. The Diagnostic Mode is exited and
normal operation resumes. Pressing the Diagnostic button, while in the Diagnostic Mode, will cause the unit to
leave the Diagnostic Mode and return to the normal time of day display.
.
1. Flow Rate (Display Code r)
Flow Rate for this particular Timer will be calculated and displayed. Flow rates will be calculated over the
time between pulses up to 20 seconds. Times between pulses longer than 20 seconds will be ignored. If
the display is flashing, the flow rate has exceeded the range and will not calculate. The display updates
once per second.
.
Display example: r100
Range = 0.0 – 99.9 gpm, 100 – 500gpm
Range = 0.0 – 99.9 m3/h, 100 – 113 m3/h
— Depress the Extra Cycle button.
2. Peak Flow Rate (Display Code P)
The Peak Flow Rate since the last regeneration will be captured. Reset to zero by holding up and down
keys for 5 seconds during the Peak Flow Rate display.
Display example: P100
Range = 0.0 – 99.9 gpm, 100 – 500gpm
Range = 0.0 – 99.9 m3/h, 100 – 113 m3/h
— Depress the Extra Cycle button.