Pentagram Cerberus ADSL2+ Lite, Инструкция по установке и эксплуатации

Страница: 46 / 75

Cerberus ADSL2+ Wi-Fi (P 6331-5)
46
Interface – Select the WAN interface to configure the QoS for outgoing packets; LAN
interface cannot be selected as VLAN is currently supported on the WAN side only.
Unclassified Packet – Some locally generated packets might not have been classified
and thus do not have a CoS value, such as PPP control packet and ARP packet. You can
define the CoS for all unclassified outgoing packets on layer 2 using this field, which will
then pick up the user priority bits based on the mapping rules you create. The selections
are (in the order of descending priority): CoS1, CoS2, CoS3, CoS4, CoS5, and CoS6.
The default value is CoS1 (recommended).
Class of Service – The selections are (in the order of descending priority): CoS1, CoS2,
CoS3, CoS4, CoS5, and CoS6.
User Priority – The selections are 0, 1, 2, 3, 4, 5, 6, 7.
•
••
•
Layer 3
Egress Layer 3 enables you to map CoS to ToS so that the priority marking of outgoing
packets can be carried over to the IP network.
Interface – Select the interface to configure the QoS for outgoing packets.
Default Non-IP – Locally generated packets (such as ARP packets) do not have a CoS
marking. You can define the CoS for all unclassified outgoing packets on layer 3 using
this field. The selections are in the order of descending priority): CoS1, CoS2, CoS3,
CoS4, CoS5, and CoS6. The default value is CoS1 (recommended).
Class of Service – The selections are (in the order of descending priority): CoS1, CoS2,
CoS3, CoS4, CoS5, and CoS6.
Translated TOS – The Type of Service field takes values from 1 to 255.