Pentagram Cerberus ADSL2+ Lite, Инструкция по установке и эксплуатации

Страница: 27 / 75

Cerberus ADSL2+ Wi-Fi (P 6331-5)
27
Enforce MTU (PPPoE only) – Check this option to enforce MTU value.
PPP Unnumbered – IP address is not assigned to PPP connection (not recommended).
Host Trigger – When On Demand is enabled, select this checkbox and click Configure
to set triggers which will enable connection.
• •• •
Static Settings
Encapsulation – Select your encapsulation type.
IP Address – Enter the static IP address here.
Mask – Enter the IP subnet mask here.
Default Gateway – Enter the gateway here.
DNS 1-3 – Enter IP address of primary, secondary and tertiary DNS Server.
Mode – Select if this connection will be Bridged or Routed .
• •• •
DHCP Settings
Encapsulation , IP Address , Mask , Gateway – Parameters obtained from DHCP
Server.
Default Gateway – Select this option if you want to use default gateway for this
connection.
Use buttons to
Renew or Release parameters obtained from DHCP Server.
• •• •
Bridge Settings
Encapsulation – Select your encapsulation type.
Select LAN – Select LAN Group from which packets will be bridged to WAN port.
• •• •
CLIP
IP Address – Enter IP Address.
Mask – Enter the IP subnet mask here.
ARP Server – Enter IP Address of ARP Server.
Default Gateway – Enter the gateway here.
WAN / ADSL Modulation
ADSL Modulation allows you to select any combination of DSL training modes. Leave the
default value if you are unsure or the service provider did not provide this information. In most
cases, this screen should not be modified.