Penrod Warmset, Руководство по установке

Страница: 8 / 32

7
Never install Warmset mat under carpet, wood, vinyl, or other non-masonry
fl ooring without embedding it in self-leveling mortar, thin-set or thick-set.
Never
install Warmset mat in adhesives or glues intended for vinyl tile or
other laminate fl ooring, or in pre-mix mortars. It must be embedded in
polymer-modi fi ed, cement-based mortar.
Never install Warmset mat under built-ins such as cabinets or vanities or
where air does not fl ow freely. Heating mats installed under built-ins such as
cabinets or vanities, or in small closets, can cause dangerous levels of heat
build-up.
Never connect the Warmset mat to the thermostat before the installation is
completed.
Never use sharp tools or power tools to clean grout lines. Cleaning grout
lines with sharp tools or power tools may damage the heating ribbon and
will void the Warmset Warranty.
Never cut the heating ribbon. If the heating ribbon is cut, it can cause
electric shock, dangerous over-heating, or fi re. If necessary, the cold leads
may be cut shorter, but never remove them completely from the heating
ribbon.
Never use metal penetrative fasteners such as nails, staples or screws to
secure the heating ribbon to the sub fl oor. Only the mesh can be stapled and
not the heating ribbon.
Never try to create a larger heating mat by splicing one heating mat to
another. Multiple mat cold leads must be connected in parallel.
Never install Warmset mats in walls or ceilings.
Never remove any labeling from Warmset mats. Make sure all appropriate
labels are visible for inspection.
Never install Warmset mats near other heat sources such as light fi xtures
and chimneys or other fl ammable devices.
Attention!
>
>
>
>
>
>
>
>
>
>
>
Never