pellenc EXCELION 2 LH, Руководство пользователя и инструкции по эксплуатации

Страница: 11 / 84

BRUSH CUTTER EXCELION 2 LH
53_154421-A
use of CITY CUT for these working conditions. Clear the work zone of all obstacles (glass, stone, metal, waste,
and other solid objects) as they can be projected when working with the cutting tool.
Never use the Brush cutter Excelion 2 LH with only one hand.
2. Always use the machine with the cutting head parallel to the ground. The safety guard no longer provides
sufficient protection if the angle of the cutting head is excessive, This can increase the risk of injury from flying
debris.
3. Immediately stop the Brush cutter Excelion 2 LH in the event of a change in the behaviour of the cutting tool
(change in noise, increased vibrations). Check that the cutting tool is properly attached and verify its condition
(no distortion, sufficiently sharp). Replace any damaged cutting tool as it can explode and cause serious, even
fatal injuries.
4. CAUTION! The cutting tool continues rotating for a few seconds after the control trigger has been released.
Always keep your hands and feet clear of the rotating cutting tool.
5. Strimmer wire
• Never remove the blade installed in the safety guard as it trims the strimmer wire to the appropriate length.
• Never use metal wire or any other material instead of the nylon strimmer wire. Metal wire is likely to break
and be projected, causing serious injuries.
• Only use nylon strimmer wire recommended by PELLENC with a max. diameter of 3 mm.
6. Cutting blades
• For the mulching blade, the maximum recommended dimensions are 280 mm in diameter and 3 mm in
thickness.
• For the tri-blade and the twin-blade, the maximum recommended dimensions are 320 mm in diameter and
2.5 mm thickness.
7. Put on the harness and carrying strap of the tool.
2.5. SAFETY MEASURES RELATED TO THE USE OF THE PELLENC BATTERY AND CHARGER
Refer to the instructions supplied with the PELLENC battery and charger.
11