Peak PEAK IOM57, Руководство по установке

Страница: 8 / 21

PEAK® IOM57 Input/Output Modules Installation Instructions
8
Wireless network applications
You can install the controller in a wireless application when you use a ZFR1811 Wireless Field Bus Router.
To configure a controller for use with the ZFR1811 Series Wireless Field Bus system:
Note: IOMs can talk wirelessly on an FC bus only.
1. On the front of the controller, connect the ZFR1811 Wireless Field Bus Router to the FC bus port (RJ-12
modular jack).
2. Ensure that the controller’s device address DIP switches are set to the correct device address. See Setting the
device addresses .
3. Set DIP switch 128 to ON enables wireless operation on the controller.
For more information about installing a controller in a wireless configuration, refer to the ZFR1811 Wireless
Field Bus Router Installation Instructions (Part No. 24-10325-1) .
Termination details
A set of Johnson Controls ® termination diagrams provides details for wiring inputs and outputs to the controllers.
See the figures in this section for the applicable termination diagrams.
Table 3: Termination details (Part 1 of 3)
Type of field device Type of Input/
Output Termination diagrams
Temperature sensor UI
Voltage input - external source UI
Voltage input - internal source UI