PCAN-Ethernet Gateway DR – User Manual
19
4.2
Reset Button
If the PCAN-Ethernet Gateway DR is no longer available due to an
incorrect configuration, the device can be reset to factory defaults
using the Reset button.
To perform a reset, press with a paper clip for example into the
small hole on the front side of the casing. Press for 1 second to
restart the device. Press for more than 5 seconds to reset the PCAN-
Gateway to factory defaults.
With a reset to the factory defaults, the IP address and the login
data are reset to the initial value (see the label on the left side of the
PCAN-Gateway). Afterwards you can perform a reconfiguration of
the PCAN-Gateway (see chapter 3 on page 11).
4.3
Signal Delay
The signal delay between the CAN connection and LAN may vary.
The transmit time of the signal in the IP network depends on the ex-
pansion and structure of the network as well as the configuration of
the message forwarding. Therefore a fixed value cannot be
specified.
