PCAN-Ethernet Gateway DR – User Manual
17
3.3
Installing the Gateway
Do the following to connect the PCAN-Ethernet Gateway DR to
an IP network (Ethernet):
1.
Mount the PCAN-Ethernet Gateway DR at the appropriate
position on the DIN rail by placing it at the top of the rail and
snapping it to the bottom.
2.
Connect each of the two CAN ports with the affiliated CAN
network.
Note:
A High-speed CAN bus needs to be electrically termi-
nated on both ends using resistors of 120
Ω
. The device
does not have an internal termination.
3.
Connect the RJ-45 connector using a LAN cable to the IP
network.
4.
Connect the PCAN-Ethernet Gateway DR to a suitable power
supply (8 - 30 V).
The PCAN-Gateway starts automatically. When the status LED is
blinking green the device is ready and the current configuration is
executed.
Note:
In case of a dynamic address assignment via DHCP, the
new IP address must first be determined. Commercial routers
list all connected devices with their current IP address.
