PCAN-Ethernet Gateway DR – User Manual
14
3.2
Basic Configuration
Change your login data first and then set up the PCAN-Gateway
connection to the LAN network.
3.2.1
Change Login Data
1.
Open the page
Device
>
User Management
.
2.
Change the login data on this page. Create a new username
and a new password.
To ensure a minimum level of security, the password should
have at least 8 characters. If possible, use letters, numbers,
and special characters.
Important notice:
Login data is confidential!
Do not act care-
lessly and leave your system open to attack. Never deposit the
login data in any form on the Internet or make it easily
accessible. Do not give the new login data carelessly to third
parties or send it by e-mail.
3.2.2
Setting up CAN
Enter the following settings to configure the CAN channels:
Open the page
Network
>
CAN
.
1.
Bit rate:
For setting the bit rate, click the drop-down menu
and select the value that is used on the connecting CAN bus.
2.
Listen-Only-Mode:
If the PCAN-Gateway should act as a
pure observer, not affecting the data traffic, Listen-Only-
Mode must be enabled. Activate Listen-Only-Mode with a
click on the checkbox.
Confirm the entries with
Save Settings
.
