Manual
82
8.4
Rectangularity program
(„Squareness programm“)
This program is used to determine the rectangularity of two planes to each other. The rotatable laser
transmitter Rl-20 can emit laser beams in an exact angle of 90° with the help of its integrated Pentaprism.
The two rectangular laser beams are used as a reference. Four measurements shall be carried out
– two
measurements on one plane and
– after the direction of the laser beam was changed – two
measurements on the other plane. Place the rotatable laser transmitter in the corner between both
planes. Now you place the receiver (sensor M set by default) on the first position. Carry out rough
alignment, if necessary.
8.4.1
Main screen of the program
What should be noted in this window
Shortcuts in this window
All required dimensions should be entered
correctly (can be changed later on, if
recommended)
Start new measurement or
repeat measurement (all
collected data will be lost)
Functions in this window
Enter dimensions
-
Enter dimensions
-
Start measurement
-
View results (available, if all required
measurements are finished)
-
Save
Save all data in one file (see
chapter 10 „Handling of the
Data Dialogue window“
)
8.4.2
Measurement process
Mark two points (near and far) on the first plane and repeat this action for the second plane. Press
and enter the distance between Point 1 and Point 2. Confirm pressing
and enter the distance
between Point 3 and Point 4. Confirm again by pressing
. Place the rotatable laser transmitter in the
corner between both planes and place the receiver on the first measurement point (far). Press
now,
to get to the measurement screen.
Distance 1-2
Distance 3-4
