Parts List
DESCRIPTION
PART NUMBER
QTY
ITEM
Raising Arm Weldment
CS-A005
1
1
Bearing Arm Weldment
CS-A002
1
2
1.034 X 0.76 Nylon
Bushing
P108
1
3
Hex Bolt
B3/8x4.5
5
4
Nylock Nut
N3/8NYL
5
5
Hex Bolt
B3/4x4.0
1
6
Nylock Nut
N3/4NYL
3
7
Carriage Bolt
B3/4x4.0C
2
8
Plain Washer
W3/4F
2
9
1-1/2 x 10 Cylinder
P1
1
10
Bearing Insert
P11
1
12
Snap Ring
P36
1
13
Minden Machine Shop Inc.
1302 K Road Minden, NE
800-264-6587 / 308-832-0220
Main Arm Assembly
4
5
10
7
9
13
12
8
3
6
2
1
1.
Install the main arms (Item 1) onto the rear main tube and align in the middle of the corn snout as was measured before.
Use the 3/8 x 4-1/2" bolts and nuts. Install the fasteners loosely so the arm can be moved to the correct location.
2.
Install the bearing arm (Item 2) on all the arms except for the arm closest to the feeder house on the left side. This is the
location for the hydraulic drive motor. Refer to main and pivot arm assembly hydraulic motor. Be sure to install the
nylon busing (Item 3) and use the 3/4" carriage bolt, washer and nut. Tighten the fastener so that the joint will pivot.
3.
Install the fore-aft cylinder (Item 10). It is recommended installing the hydraulic fittings and then install the cylinder.
The hydraulic elbows should be facing towards the combine to aid in hydraulic hose attachment. Use the 3/4 bolt, 3/4"
carriage bolt, washers, and nuts to install. These areas will need to pivot, so when tightening the fasteners, be sure the
area can pivot.
4.
Align all the main arm assemblies in the middle of the associated corn snout and tighten in place.
5.
Item 12 and 13 are pre-installed at the factory.
Crop Sweeper V 10.0
39
