Parts List
DESCRIPTION
PART
NUMBER
QTY
ITEM
Left Rear Hyd Cylinder Lower Link Plate
CS-P001
1
1
Right Rear Hyd Cylinder Lower Link Plate
CS-P002
1
2
2 Bolt Flange with 1-1/4" Bearing
P4
2
3
2.5 x 8 Cylinder with #6 SAE O-ring Fittings
HCY1004
1
4
Chain and Quick Pin 7 1/4" Overall Length
CSP14
1
6
Safety Lock Bearing Ear Mounting Plate
CS-P032
2
7
Gator Clamp Weldment
CS-A004
1
8
Hex Bolt
B5/8x1.5
8
10
Nylock Nut
N5/8NYL
8
11
Hex Bolt
B1/2x1.5
12
12
Nylock Nut
N1/2NYL
4
13
Universal Mount
CS-P079
1
15
Minden Machine Shop Inc.
1302 K Road Minden, NE
800-264-6587 / 308-832-0220
15
7
10
1
2
3
12
4
8
6
13
11
Main Lift Cylinder Assembly
1.
After determing the bracket locations, take support bracket (Item 15) and depending upon which mounting you have,
insert the top two bolts and nuts and install loosely by hanging over the top of the corn head bar in the desired location.
2.
Using the clamp plate for your mount, use it as a template to drill two 5/8" holes through the sheet metal on the back of
the corn head. After the holes are drilled, install the bolts, washers, and nuts. Once the bracket is in the correct
location, tighten the fasteners.
3.
Repeat with the other side.
4.
Install the lift cylinder lower link plates (Item 1 and Item 2) onto the universal mount (Item 15). Mount the lower link
plates in the center group of holes as a starting point with the notches up. The cylinder mount holes (1" diameter) are
offset by a 1/2" compared to the 5/8" diameter holes so that adjustment is in 1/2" increments. The position can be
altered if needed. Use the 5/8" x 1-1/2" bolts and nuts to mount.
5.
Install the 1-1/4" flange bearing (Item 3) to the bearing ear mounting plate (Item 7) using the 1/2 x 1-1/2" bolts and
nuts.
6.
Slide the assembled flange bearings onto each side of the Gator Clamp Weldment (Item 8) with the bearings towards
the outside. Attach the bearing ear mounts (Item 7) to the universal mount (Item 15) and bolt in the middle set of holes
with the 5/8" x 1-1/2 bolts and nuts. Center the Gator Clamp assembly. Tighten the fasteners and then tighten the
bearings onto the shaft of the Gator Clamp Weldment.
7.
Remove the plastic plugs from the cylinder (Item 4) and extend the ram. Connect the cylinder to the lower link plate
with the supplied cylinder pin and then connect to the Gator Clamp with the ram end with the other supplied pin.
Install retaining clips. Make sure the hydraulic ports are accessible.
#Be sure that all
fasteners are
tightened
correctly!
Crop Sweeper V 10.0
23
