Parweld DP231C, Руководство пользователя

Страница: 9 / 26

WELDING WIRE
To load the welding wire, follow these instructions
carefully, in the order described below. Warning:
before inserting the wire, always remove the gas
nozzle and the wire feeder tip from the welding
torch.
1. Disconnect the cable from the power supply
(18 of Fig. 2).
Caution: before proceeding with the next
step, make sure the torch cable (Fig. 4) is well
extended and that the welding wire does not
have any bends or burrs. Failure to follow these
precautions could damage the wire-feeding tube
inside the torch. Once the wire has been threaded
through the torch, attach the wire-feeder tip and
the gas nozzle.
N.B. When changing the diameter of the wire,
make sure that the correct cable of the wire-
feeder spool is facing towards the inside of the
machine. To do so, ensure that the diameter and
type of wire is legible (facing towards the outside
of the machine) Remember that the spools with
2. Unscrew the
ball-grip knob in
the centre of the
spool support of the
welding wire (22 of
Fig. 3).
3. If necessary,
depending on the
size of the spool
used, remove the
bearing spool.
4. Remove the
plastic wrap from the
new spool and place
the spool on the
appropriate support
(22 of Fig. 3).
4. Replace the ball-
grip knob.
5. Please note that
the hex socket (M8)
situated in the centre
of the spool support
is part of the wire
tension system.
6. Lower the roll
feeder (25 of Fig.
3A)
7. Insert the wire
into the inlet tube
(26 of Fig. 3A) of
the wire feeder
motor. .
8. Run the wire
under the wire
feeder spools all the
way to the out-let of
the Euroconnector.
9. Lower the
upper spools
10. Lift the knob of
plastic (25 of Fig
3A) of the pressure
regulator of the
wire.