Parweld DP231C, Руководство пользователя

Страница: 7 / 26

8. USB port: only for technical assistance.
9. Knob for setting the main welding parameter:
the main welding parameter can be set with
this knob: Welding MMA/TIG: sets the welding
current.
11. Air grills (must never be obstructed).
12. “-” dinse front connector: negative pole inlet.
Connection socket TIG torch mode. MMA Mode:
Ground clamp MIG Mode: Ground clamp
13. Connector for remote control.
14. “+” dinse front connector: positive pole inlet.
MMA Mode:Electrode holder TIG Mode:Ground
clamp MIG Mode with gas: Not used
15. Gas Outlet: MMA Mode: inactive TIG Mode:
Gas connection to the welding torch (Internal
tap positioned on TIG GAS) MIG Mode with gas:
inactive (internal tap positioned on MIG GAS) 16.
EUROCONNECTOR (SEPARATED TROLLEY):
quick connector for welding torch. This connector
is used to supply welding gas to the torch, the
electrical contacts of the torch button and the
welding current.
FIGURE 2:
17. ON-OFF switch: turns the machine on and
off.
18. Input cable: connection cable to the mains
power equipped.
19. Welding gas inlet MMA Mode: Not used TIG
Mode: GAS connection to the cylinder MIG Mode
with gas: GAS connection to the cylinder
20. Fuse
21.Connector for supplying power to the
Graphic display: The display 5.7 inch color’’
shows different screens depending on whether
the machine is in welding mode or setting mode.
In welding mode, the display is divided into five
main parts:
Part 1: State of the machine
Part 2: Meaning of the active buttons (buttons 2,
3, 4, 5 of fig. 1)
Part 3: Value of the measurements set
Part 4: Type of process selection
Part 5: Indicates the values set for the various
welding parameters (to change the set value,
highlight the value with knob 10 and press to
confirm; the value is highlighted as a contrast.
Change the value by turning the knob and confirm
the new value by pressing knob 10 again).
Highlighted value: Indicates the welding
parameter that is being changed with knob 10.
VIEWS: - At start-up, the Parweld logo and the
Firmware revision are displayed.
CONTROL BUTTONS: (2, 3, 4, 5,6 in fig.1)
Each control button is associated with a specific
function shown on the display.
7.SD slot: This slot, covered by a special plastic
cover, must contain the SD-Card supplied with
the machine; without this card, the machine
remains inactive and a special signal is reported
on the display.
liquid cooling system (Optional): Warning the
connector contains dangerous voltages: NEVER
use it for purposes other than those for which it
was specifically designed.
Part 1
Part 2
Part 3
Part 4
Part 5